Moisture mapping
Leak investigation & diagnostics
Water travels. It enters at one point, tracks along slabs, beams and cavities, and appears somewhere else entirely, which is why remediation scoped from where the stain shows up so often rebuilds the wrong element. Diagnostic investigation uses flood testing of isolated zones, moisture meters and thermal imaging to trace the path back to its source, producing a written findings report that turns the rectification quote from an estimate into a scope.
Scope
What this covers
Staged flood testing to isolate which element actually admits water
Moisture mapping and thermal imaging across affected walls, floors and soffits
Inspection of flashings, junctions, sealant lines and drainage points
Written findings identifying the failure source and recommended rectification
Re-testing after rectification to confirm the entry point is closed
Timing
When it's needed
Intermittent leaks that defy pattern, disputes over whether a leak originates in a lot or in common property, buildings where several patch attempts have already failed, and pre-purchase or pre-litigation situations where someone needs the cause established rather than assumed.
Water tracking through a building can reach electrical fittings and weaken ceilings. Keep clear of sagging or stained plasterboard, never touch light fittings or switches that are damp, and isolate the affected circuit and seek help promptly where water and electricity may have met.
Quote variables
What shapes the scope
Number of potential source elements that must be isolated and tested separately
Access to the areas above and below the leak path, including neighbouring lots
Whether testing must run across multiple weather events to reproduce the fault
Reporting depth required: maintenance guidance versus evidence-grade documentation
Waterproofing is a licensed trade in NSW, and remedial building work on apartment buildings additionally engages the design and building practitioner regime, under which designs are declared and practitioners registered. Whoever performs your remediation, ask for their contractor licence and any applicable practitioner registration, and verify both on the NSW online registers before work is engaged.
Remediation scopes
Start your quote
Send through the job details and we'll connect you with a licensed provider who can quote this work.
If this is an emergency or anyone is at immediate risk, contact the relevant emergency service or your network or utility operator directly instead of using this form.